Hi,
is it possible to run the CPU on the TF536 with 40MHz, means just replacing the Oscillator?

dont worry, found the mistake - all fine!

I ve tested both cards now in my Amiga.

1 card is working - so programming should be done indeed successfully

The second card is reported as defective - Amiga Testkit is reporting 0MB RAM.

I will check all connections to the RAM chips. Any further hints?

ok, thanks... 1 step further... programming is done successfully in about 7 seconds, but I am getting an error while verifying I ve looked at what else I can read after programming... Device ID '1': IDCODE is '59616093' (in hex). '1': : Manufacturer's ID = Xilinx xc95288xl, Version : 5 Device Checks...

the last dialogue I am getting is in the attached picture

Hi, today the XILINX Platform Cable DLC9LP arrived. Totally exited I was able to install the ISE iMPACT on my W10 x64 machine, but now I am really grounded with the software. Starting iMPACT 64 it opens, clicking "Initialize chain" it shows the correct chip on both TF536 I ve build, it askes for the...

Ok, great hint - I ve ordered one.

Can you point me as well to the last Firmware please?

Hi,
I ve just finished my 1st build.
How can I program the Xilinx controller - Raspberry is available.
I ve got a Revision 2B Board, but only find a Alpha Firmware at Github.

Any help is being appreciated - sorry for my beginner question

can I do that via jumper or do i need a new oscillator?

tried both, no change