What did you go for in the end then ? It was a module someone sent me. I think they are being made by Mathesar on Amibay. It`s tbtorro(Joszef) on Amibay who sells these modules in kit form, check his sales thread out here: http://www.amibay.com/showthread.php?106925-Micro-PSU-component-kits-for-060...

Those reprinted CPUs are absolutely horrible. I had a batch of about 60% of them that refused to work. Reprinted crap. It's almost a good thing that nobody wants the 330s anymore so i don't have to worry about these things :D Anyway, on the 536 using an EC variant is not a good idea since the Fastro...

Hi Viktor, yes it does look like the 40mhz are now only freescale and I have bought a shit load over the last six months, also with the burst mode on the TF330 then some will not run when overclocked 50mhz but I was prepared for that and so have priced it in the CPU cost ,as mine have a fail rate of...

Yes bud it does hang with the S folder but that is because there so much stuff in it lol so it takes an age to show all the files, the thing is this is an old early image now and has not been shipped with TF328 for over 12 months and the new image that I ship uses about 4mb on boot so your TF534 wil...

Ok... Have tested this image on CD32 with TF328 - and got same result, so this is image Mark sent me after all.. That is strange as that image works fine on my TF328 and TF330, but I do not have a A500 TF534 so can`t test it. also it is for AGA CWB WB 3.1 based machines and that is what the problem...

Hi Viktor, ask Toni Willen as he might have the answer or I don`t know if he has an A500 so someone can donate a TF534 to him to investigate, just a couple of Idea`s to throw into the mix

So it was a bad download I managed to program the TF330 with the above jed and the CD drive does not boot at all with a CD rom in it, it just goes to the Cd32 splash screen...is this the same for you Allen ?

here is some software install it then: 1, select your device(your Eprom chip) 2.load your file 3 under the `Action` tab select `byte swap` 4. save your new file(its now byte swapped) if you get errors when running the software dont worry just carry on its just when its loading the program( I use win...

Ok mine must have been a corrupt download. will try it again tomorrow

Hi Steve, that JED file will not program , comes up with file error when trying to program with x3sprog