matt020 wrote: ↑

Wed Nov 11, 2020 10:01 pm

Have you got the additional wire connected to Gary?

Can you upload a picture of the chip and how it is installed into the motherboard?

Yes, the cable is connected to pin 36 of the Gary. The green screen doesn't show it anymore. The system boots, but always shows little chipram.

Hi, These days I found a DKB MegAChip, I connected it following what is written in the manual. But I have noticed that when I turn on my computer I sometimes get a green screen and then it continues booting. I also saw that on the upper line of the workbench where the memory is indicated that the Ch...

terriblefire wrote: ↑

Mon Nov 09, 2020 6:27 pm

GianDO wrote: ↑

Mon Nov 09, 2020 6:26 pm

As @ 8 Bit Dreams I can't find he. Are these cards made only by him?

He's a moderator on this forum. I dont know who make the TK cards it changes all the time.

Hi,
last night I wrote to 8 Bit Dreams in pv because I saw that he responded in some posts. I also hope for an answer.

terriblefire wrote: ↑

Mon Nov 09, 2020 6:27 pm

GianDO wrote: ↑

Mon Nov 09, 2020 6:26 pm

As @ 8 Bit Dreams I can't find he. Are these cards made only by him?

He's a moderator on this forum. I dont know who make the TK cards it changes all the time.

But is it possible to contact Matze (aka Matthias Heinrichs) directly?

I wrote in DjCook's post on amibay for a TK 030 at the beginning of the second half of October, but he never replied .. what can I do? DjCook is also @8 Bit Dreams ... think he recently had a baby so maybe not taking orders. As @ 8 Bit Dreams I can't find he. Are these cards made only by him?

Probably your only option is Vampire or a 68030 TK. http://www.amibay.com/showthread.php?99425-68030-TK-Another-accelerator-card-for-Amiga-A500-A1000-A2000-designed-by-Matze-(aka-Matthias-Heinrichs) Ok, the TK 68030 might interest me, it is could be a great solution for A2000, Now I have to find a ...

1 minute and 36 seconds pass from when I turn on the computer until the WB screen appears. They seem a little too many. I noticed that during the boot there are some initial stall phases with the hard disk LED that seems to be on steady, then after a minute it flashes and loads the WB even if the f...

And it doesn't (or shouldn't) take long to scan the chain anyway. It should take a matter of seconds. 1 minute and 36 seconds pass from when I turn on the computer until the WB screen appears. They seem a little too many. I noticed that during the boot there are some initial stall phases with the h...

Si ma io vorrei conoscere come vanno settati. Please keep it in English! SCSI address setting is a rather large user land subject. My guess is you are setting the controller ID there and unless you know what you are doing leave it alone as you found it. The controller is usually ID7 so all jumpers ...

On this card there are also jumpers for SCSI IDs, there are 3 jumpers J10, J11 and J12. The manual explains only the position of the jumpers for the RAM, but not that for the SCSI IDs. Do you to know the settings of these jumpers? Thanks At a guess they'll be the SCSI address. Those are usually 3 b...