Is the idea here to provide a floppy drive connector or to emulate the floppy on the riser? Perhaps the Gotek schematics could be of assistance here?


* Disclaimer * I'm unsure if the attached are up to date or even accurate, but might help for guidance.

terriblefire wrote: ↑

Thu Mar 19, 2020 12:53 pm

Swapped the pins.

Good call!, ... "For the many, not the few"

terriblefire wrote: ↑

Wed Mar 18, 2020 5:52 pm

Hows this for a dilema...

2 vias or swap the pin assignments and break firmware compatibility...

What was the decision? I would have swapped the pins and broken compatibility! It's only Chucky, alenppc and supaduper after all ...

I'm tempted to vote no as it seems to go against the stripped down ethos of the board. I run a 150mm cable on the TF330 without any issue, although admittedly I've never done a speed comparison on different cables as it's not that important to me. I assume some people would want a long cable here in...

As TF was kind enough to send me one of the second batch of TF536 boards to build and test I decided to modify the Original AwesomeInferno re-locator design to allow the slightly larger design footprint of the 536 board to clear the two large 3300uf caps on the A500. I ended up making a few changes ...

terriblefire wrote: ↑

Mon Mar 09, 2020 10:10 pm

My central heating has packed in so didnt get near the lab tonight.

From the dry heat of the desert, back to Scotland with no central heating - Ouch!

Hi Exxos,

I'm no expert but it looks like you're mixing Verilog and VHDL syntax in the above example?

Very positive from me. Feels familiar to build due to the 330 -esque RAM / CPLD layout and the SMD assembly on the underside is definitely a winner. Nit picking here but If you're flipping RN3? (The 10K) and C85 to the underside for assembly would it be possible to then space the clock multiplier sl...

Higgy wrote: ↑

Tue Feb 11, 2020 7:55 am

go0se - What motherboard revision is your 'boneshaker' and what is the 'nice' one?
Thanks

Both are 1.D4

TF1260 has now been fully assembled. Supaduper took pity on me and posted out a proper regulator, so thanks again for that! Initial test I had what seemed to be issues with the all the standard Amiga PSUs I tried. They booted the card successfully but crashed within a few minutes under load. Switchi...