Both look good! I like the layer of authentic storage dust on Continental Circuit rather than someone trying to tart it up for sale. Not sure I've ever seen an Operation Wolf cabinet with some paint left on the gun, usually chipped useless and leaning badly to one side or the other! :) If you look i...

terriblefire wrote: ↑Fri Dec 03, 2021 8:23 am Operation Wolf. Both in need of work .

Fingers crossed you don't need any parts for the Operation Wolf controller, could cause a few awkward questions at the Post Office and a knock at the door!

Just for reference my IDE cables are 20cm so perhaps that extra 20cm is problematic for some, and anyway if you want longer cables you need to buffer the IDE, so that then entails trying one of the various buffer adapters that are available for Amigas..I have never tried one :) A 'plug in' buffer d...

DoG wrote: ↑Thu Dec 02, 2021 4:46 pm I says they do now:

· 2&4&6 layer
· Green/Black/Blue/Red/White solder mask

https://jlcpcb.com/smt-assembly

That's incorrect, 4 and 6 layer are still only available in green with assembly. This is from the order page.

After a long hiatus I went back to the EDA drawing board board with this and came up with something more 'elegant' that doesn't require placing the IDE header in an unnatural orientation / messing with pin locations. This time the daughter board steps the IDE header down as far as possible using 12m...

part12studios wrote: ↑Fri Nov 26, 2021 3:09 am but all signs indicate the unit.

a) Works ?
b) Doesn't work ?

Cheers. Interestingly, the version of Drool This available on Demozoo/Scene.org has a text note attached which reads This is fixed version of the our demo that was released at the Assembly '94. Now it is as it should have been. Wolf-routine has a little bug that crashes the machine sometime. Enjoy t...

Danoo Can you confirm the two issues below are resolved during your tests? They are still present on my test setup. Cuzco / Oxygene - artifacts on screen during cube / cheese display. Drool This / Parallax : (can be found in supaduper's archive) With the latest firmware, starts and runs then Gurus ...

Boots without issue on a 2B here.

Does it boot again when you revert to the previous FW?

I've updated the test post earlier in the thread with some more results. This one is interesting: Drool This / Parallax : This one wasn't available in my WHDLoad demo archive so have used the version in Supaduper's upload. With the latest firmware, starts and runs then Gurus the machine about 5 seco...