This current Falcon I am fixing as a Motorola RTC. I have not actually seen one of these before.. And a little more annoying to the solder than the Dallas ones.
This one I cut around the edges near the bottom to take off the plastic..
you can just about see the oscillator still on the left...
all the pins were cut as normal...
Then next job is branching onto the normal desoldering which I already videoed..
https://www.exxosforum.co.uk/forum/viewt ... f=35&t=345
As a side note, chip does seem to have a plastic cover of course, and it just seems to be hot snotted into place. It could be possible to remove the top cover as a whole without breaking it.. But I did not want to risk it and did not want to end up trying to leaver the top off and risk damaging the motherboard.
Falcon MC RTC CHIP
Falcon MC RTC CHIP
https://www.exxosforum.co.uk/atari/ All my hardware guides - mods - games - STOS
https://www.exxosforum.co.uk/atari/store2/ - All my hardware mods for sale - Please help support by making a purchase.
viewtopic.php?f=17&t=1585 Have you done the Mandatory Fixes ?
Just because a lot of people agree on something, doesn't make it a fact. ~exxos ~
People should find solutions to problems, not find problems with solutions.
https://www.exxosforum.co.uk/atari/store2/ - All my hardware mods for sale - Please help support by making a purchase.
viewtopic.php?f=17&t=1585 Have you done the Mandatory Fixes ?
Just because a lot of people agree on something, doesn't make it a fact. ~exxos ~
People should find solutions to problems, not find problems with solutions.
Re: Falcon MC RTC CHIP
It actually is possible to remove the cover as a whole.
At least if you desolder the chip before and put a screwdriver from the bottom between the cover and the chip.
(more 20MP hires-pics in my Flickr-album)
At least if you desolder the chip before and put a screwdriver from the bottom between the cover and the chip.
(more 20MP hires-pics in my Flickr-album)