Page 1 of 1

[pics] 1.62/2.06 switcher build

Posted: Sun Oct 22, 2017 12:54 pm
by spiny
Hi All,

some new pics on building up the STe switcher, just to show how easy it is, in case anyone is putting off ordering one due to soldering worries :)

pics were taken with a 'go pro' cheap knockoff I'm experimenting with, so not the best quality, but there are better pics I did on another build here: http://www.spiny.org/atari/photos/exxos ... index.html

I have three of these kits now, and they are well worth the upgrade. If you just use the jumper rather than drill thecase for a switch, it's possible to go back to stock too.
01.JPG
01.JPG (1.49 MiB) Viewed 1913 times
02.JPG
02.JPG (1.6 MiB) Viewed 1913 times
03.JPG
03.JPG (1.62 MiB) Viewed 1913 times
04.JPG
04.JPG (1.54 MiB) Viewed 1913 times
05.JPG
05.JPG (1.47 MiB) Viewed 1913 times
06.JPG
06.JPG (1.63 MiB) Viewed 1913 times
07.JPG
07.JPG (1.63 MiB) Viewed 1913 times
07.JPG
07.JPG (1.63 MiB) Viewed 1913 times
09.JPG
09.JPG (1.61 MiB) Viewed 1913 times
10.JPG
10.JPG (1.51 MiB) Viewed 1913 times
to make sure the pins are straight, I put them in a socket firts, then line them up on the board.
11.JPG
11.JPG (1.5 MiB) Viewed 1913 times
12.JPG
12.JPG (1.52 MiB) Viewed 1913 times
13.JPG
13.JPG (1.62 MiB) Viewed 1913 times
14.JPG
14.JPG (1.62 MiB) Viewed 1913 times
15.JPG
15.JPG (1.65 MiB) Viewed 1913 times
all done
16.JPG
16.JPG (1.49 MiB) Viewed 1913 times

Re: [pics] 1.62/2.06 switcher build

Posted: Sun Oct 22, 2017 1:25 pm
by exxos
:coolpics: :goodpost: