Great, I just gave you something else to break.exxos wrote: ↑Fri Jan 21, 2022 3:48 pm I think this stuff came with the i3 like 8 years ago.. It is just bin lay my workshop the entire time. I do have some new stuff but it does not fit the spool holder on the printer I guess I will have to try and hacksaw the centre out of it so it will fit and I can use the stuff.
It's a bit of a stab in the dark, but you might want to look into some of the oven drying methods and see if it affects your print quality. Basically you just pick a correct temperature for your material (look into this, I think it's something like 80°C for PLA?) and leave it in the oven for a few hours. It's worked well for me on old filament that absorbed too much moisture.