exxos blog - random goings on

[exxos]

Printing my new i3 exclude the fan duct.

80000mm/min , 400 accel.

[PhilC]

That looks more like it now

[exxos]

Challenge will be getting the infill out

IMG_6844.JPG (275.01 KiB) Viewed 1870 times

[exxos]

Dammit! When using knives member to cut away from your fingers folks I got a good deep inch long cut in my finger Good job it was lengthways and not across!!

Capture.JPG (39.63 KiB) Viewed 1855 times

Now to go clean up the kitchen as it looks like a crime scene now

[exxos]

As it was impossible to get the support in-fill out.. For the hell of it I just tried printing without it, and was amazed it wasn't a total disaster

IMG_6847.JPG (184.78 KiB) Viewed 1842 times

IMG_6848.JPG (255.34 KiB) Viewed 1842 times

[JezC]

Dammit! When using knives member to cut away from your fingers folks I got a good deep inch long cut in my finger Good job it was lengthways and not across!!

Now to go clean up the kitchen as it looks like a crime scene now

Ouch! Careful or you'll get a similar reputation to @rubber_jonnie and his (finger) soldering iron!

[exxos]

Ouch! Careful or you'll get a similar reputation to @rubber_jonnie and his (finger) soldering iron!

My injuries I think are normally a lot worse, don't you remember my "eye" pictures from a while back

[JezC]

My injuries I think are normally a lot worse, don't you remember my "eye" pictures from a while back

I'd not seen those...very nasty! Just so long as the injuries don't halt you progress battling with those pesky printers!

[rubber_jonnie]

Dammit! When using knives member to cut away from your fingers folks I got a good deep inch long cut in my finger Good job it was lengthways and not across!!

Now to go clean up the kitchen as it looks like a crime scene now

Ouch! Careful or you'll get a similar reputation to @rubber_jonnie and his (finger) soldering iron!

I bet you run with scissors too......

Hope it isn't too bleedy.

[exxos]

Has anyone come across this problem ?

When it is doing the internal infill, the change of direction from right to left seems to place down filament and ends up being a "blob" higher than the rest of the print layer..

I have tried changing the overlap between infill and parameters, extruded retraction, speeds up the print.. Nothing seems to do anything at all

Oddly on the left-hand side of the print it does not seem to have that problem.

IMG_6849.JPG (213.25 KiB) Viewed 1824 times