Page 15 of 15

Re: Projects and Stuff

Posted: Wed Oct 21, 2020 9:41 am
by rubber_jonnie
@PaulJ I'm pretty sure that list isn't comprehensive, especially since each category will have sub categories 😁

There may even be some missing.....

:D

Re: Projects and Stuff

Posted: Wed Oct 21, 2020 1:49 pm
by PaulJ
PhilC wrote: ↑
Wed Oct 21, 2020 7:34 am
Thanks @PaulJ , do you also have a guide for correct chip orientation?
Phil, I would have included an orientation guide but for fuses they can be inserted either way. I would watch out for the brass fuse though maybe insert the pointy end away from ya. :D :D :hide:

Re: Projects and Stuff

Posted: Wed Oct 21, 2020 3:36 pm
by PhilC
@PaulJ seems like reasonable advice.

Re: Projects and Stuff

Posted: Wed Oct 21, 2020 4:04 pm
by PaulJ
PhilC wrote: ↑
Wed Oct 21, 2020 3:36 pm
@PaulJ seems like reasonable advice.
Just purchase the better part of two 1040’s and both had supplies with missing fuses. Assume the supplies are suspect but had to order fuses just not the ones pictured. I would guess a lot of the current ratings are bad. Don’t believe the flip top could do 130 amps not to mention some of the other ratings.

Re: Projects and Stuff

Posted: Mon Nov 02, 2020 9:10 pm
by stephen_usher
Re: NetUSBee
I thought I'd try it again in the STFM with TF536 and I monitored what the CPU actually sees.

Very interesting. It doesn't pull the bus down very well. It's extremely weak. Most of the bits hardly make it down to TTL low levels of voltage, and many don't.

Re: Projects and Stuff

Posted: Mon Nov 09, 2020 5:10 pm
by PaulJ
stephen_usher wrote: ↑
Mon Nov 02, 2020 9:10 pm
Re: NetUSBee
Very interesting. It doesn't pull the bus down very well. It's extremely weak. Most of the bits hardly make it down to TTL low levels of voltage, and many don't.
Ya know that maybe a good clue. We have decreased the resistance values of the pull-ups which could cause a higher low if being driver with a weaker device. I've been playing with the bee on the H5 and part of the issue is the recycled cartridge connector. After a good cleaning and a lub with some electronic cleaner its much better. However its not a 100%... usually works booting from a cold system. But if its been on for some time it fails occasionally. Another funny thing is you can start it cold, exit and restart hours later and it works. Without that cold start its a top up if its going to start when warm.

Re: Projects and Stuff

Posted: Mon Nov 09, 2020 6:43 pm
by exxos
Even 2.2K pull ups is only 2.2mA... What it using to drive the bus anyway ? if it cant pull down a couple of mA then its going to need some buffering to work properly.