Reverting Skunk.
Posted: Mon Apr 01, 2019 10:21 pm
Hi,
I'm having some problems with my scsi interface on my skunkified Falcon and I thought I'd remove everything that's not stock in the machine just to be sure. And the Skunk does not work, just freezes my machine when loading Skunk32.
Looking at the PCB and comparing it to the 74F04 fix over here one can see that the trace by R216 should not be cut in this case (but when using 74f08). (The black wire top left is going to RST on U24)
What I would like to have is a manual for the Skunk, but I haven't found it on the internets, just to be sure that I revert everything. If I can't find this I guess I should:
1. Desolder all Skunk wires.
2. Go over the mobo once again to look for any cut traces.
3. Run a wire from pin 12 on the 74F04 to R216.
Gentlemen and gentlewomen, any input?
I'm having some problems with my scsi interface on my skunkified Falcon and I thought I'd remove everything that's not stock in the machine just to be sure. And the Skunk does not work, just freezes my machine when loading Skunk32.
Looking at the PCB and comparing it to the 74F04 fix over here one can see that the trace by R216 should not be cut in this case (but when using 74f08). (The black wire top left is going to RST on U24)
What I would like to have is a manual for the Skunk, but I haven't found it on the internets, just to be sure that I revert everything. If I can't find this I guess I should:
1. Desolder all Skunk wires.
2. Go over the mobo once again to look for any cut traces.
3. Run a wire from pin 12 on the 74F04 to R216.
Gentlemen and gentlewomen, any input?