exxos's Atari, Amiga & retro forum

It's the one that's incorrectly rotated that annoys me

Forgottenmyname wrote: ↑Mon Aug 06, 2018 5:46 pm It's the one that's incorrectly rotated that annoys me

Forgottenmyname wrote: ↑Mon Aug 06, 2018 5:46 pm It's the one that's incorrectly rotated that annoys me

Surely it's all but one is the wrong way around?

stephen_usher wrote: ↑Mon Aug 06, 2018 5:50 pm

Forgottenmyname wrote: ↑Mon Aug 06, 2018 5:46 pm It's the one that's incorrectly rotated that annoys me

Surely it's all but one is the wrong way around?

so that's why I found it annoying.

I don't like the gap between 1st and 2nd of the middle row

One thing I noticed the other day which I need to look at the bit more.. Was that HD10.01 driver crashed on boot up in 40MHz mode. I am not sure if anything else was loading in the AUTO folder.. I need to check will not had chance yet..

Basically when HD10 loaded it would bomb out. You'll thing is if I booted in 8MHz mode it would all load fine, and then the driver seemed to work fine in switching back to 40MHz mode. I emailed Uwe about it, he says it works on other machines like the Milan etc and that there is no timing dependent code in HD10..

So if any of you guys with this booster can try it out, really just load the driver from the floppy, and see if it bombs on boot or not.. I will try and do this myself bought I'm going to be busy today some other stuff..

EDIT:
The driver might actually loaded from my ultra Satan... Can't remember now

Will try and give it a go this weekend from Floppy.

I don't suppose you have a link to the file do you? Still an STe newb here.

I have an ultrasatan but only the correct cables for a Mega ST.

Forgottenmyname wrote: ↑Thu Aug 09, 2018 8:22 pm I don't suppose you have a link to the file do you? Still an STe newb here.

HD10 isn't "free software" but there is a demo...

https://www.hddriver.net/en/demo.html

Going back to the images in my previous post https://www.exxosforum.co.uk/forum/viewt ... =220#p8057

There has been no progress with these over the past month So I am going to send them off to get the headers soldered onto them as I can't see myself getting time any time soon.

Well mine certainly seems to work ok. I'll put it on test again over the weekend.

I think you've got a good product you can sell just fine, just need to get it on the shelf.