exxos's Atari, Amiga & retro forum

Hi,

Bought one of these (from websshop) at the end of September and only just got a monitor (Dell U2410) that it
will work on. High resolution is fine, if a little fuzzy but I cannot seem to find any software to make it work
in medium/low res.

Is this software available yet?

Thanks

Short press on the little button should change resolution.

DoG wrote: ↑Sat Dec 08, 2018 3:53 pm Short press on the little button should change resolution.

Thanks, I missed that.

exxos wrote: ↑Sat Dec 08, 2018 3:55 pm https://www.exxosforum.co.uk/forum/viewt ... f=27&t=161

Thanks.

"The board also holds 3 trimmer resistors to alter the RGB levels. 3.5mm A/V connector with volume control and autodetection of resolution (in software)."

Hello,
Ok, failry dense question I'm sure, but what is the wheel supposed to do? On my setup it appears to make no difference to the output.

Thanks

Volume control for the jack.