Page 1 of 1

Software for "UBE VIDEO ADAPTER" ?

Posted: Sat Dec 08, 2018 3:07 pm
by thedavegray
Hi,

Bought one of these (from websshop) at the end of September and only just got a monitor (Dell U2410) that it
will work on. High resolution is fine, if a little fuzzy but I cannot seem to find any software to make it work
in medium/low res.

Is this software available yet?

Thanks

Re: Softwaew for "UBE VIDEO ADAPTER"

Posted: Sat Dec 08, 2018 3:53 pm
by DoG
Short press on the little button should change resolution.

Re: Softwaew for "UBE VIDEO ADAPTER"

Posted: Sat Dec 08, 2018 3:55 pm
by exxos

Re: Softwaew for "UBE VIDEO ADAPTER"

Posted: Sun Dec 09, 2018 1:32 pm
by thedavegray
DoG wrote:
Sat Dec 08, 2018 3:53 pm
Short press on the little button should change resolution.
Thanks, I missed that.

Re: Softwaew for "UBE VIDEO ADAPTER"

Posted: Sun Dec 09, 2018 1:33 pm
by thedavegray
exxos wrote:
Sat Dec 08, 2018 3:55 pm
viewtopic.php?f=27&t=161
Thanks.

Re: Software for "UBE VIDEO ADAPTER" ?

Posted: Sun Dec 09, 2018 4:44 pm
by thedavegray
"The board also holds 3 trimmer resistors to alter the RGB levels. 3.5mm A/V connector with volume control and autodetection of resolution (in software)."

Hello,
Ok, failry dense question I'm sure, but what is the wheel supposed to do? On my setup it appears to make no difference to the output.

Thanks

Re: Software for "UBE VIDEO ADAPTER" ?

Posted: Sun Dec 09, 2018 4:50 pm
by exxos
Volume control for the jack.