Page 1 of 1

Case for 520ST PSU remake

Posted: Sun Apr 14, 2019 11:58 am
by rubber_jonnie
Gcode files for 3d printing the remade PSU case. These are set to print faster, so quality may not be as high as you'd wish, if not change the layer thickness from .3 to something less in your prefferred software.

Re: Case for 520ST PSU remake

Posted: Thu Sep 26, 2019 12:33 pm
by ctirad
Thanks, but why do you distribute gcode instead of an stl?
I'd like to slice it for my printer and filament setup.

Re: Case for 520ST PSU remake

Posted: Thu Sep 26, 2019 4:50 pm
by rubber_jonnie
ctirad wrote:
Thu Sep 26, 2019 12:33 pm
Thanks, but why do you distribute gcode instead of an stl?
I'd like to slice it for my printer and filament setup.
Sorry, that was an oops on my part, I uploaded the wrong ZIP file. New one is attached.

Can also be found on Thingiverse: https://www.thingiverse.com/thing:2701695

Re: Case for 520ST PSU remake

Posted: Thu Sep 26, 2019 4:52 pm
by rubber_jonnie
Also, don't do what I did, and try to get the print time down by changing the layer height etc, it made my print finish faster, but I had a lot of problems with the top vents.