Page 1 of 1

programming with a raspberry pi guide

Posted: Mon Sep 14, 2020 3:16 pm
by oggie
I'm trying to flash my tf330 I bought from alenppc using a raspberry pi. But I forget the connections and exact commands. The wiki is now gone from github, which was very helpful, so I'm at a loss as to what the process is.

Does anyone have a guide or a copy of the wiki page they could send me?

Re: programming with a raspberry pi guide

Posted: Mon Sep 14, 2020 8:04 pm
by oggie
Answering my own question here, but I think it's this for Pi Ver 1:
Pin 7 (GPIO4) -> TMS
Pin 15 (GPIO22) -> TDI
Pin 13 (GPIO27) -> TDO
Pin 11 (GPIO17) -> TCK
Pin 1 -> 3.3v

And the command is:
sudo xc3sprog -v -c sysfsgpio_creator -p 0 <insert filename here>.jed:w

Re: programming with a raspberry pi guide

Posted: Mon Sep 14, 2020 8:10 pm
by kludge
I think it depends on the model of Pi used. @terriblefire didn’t even specify the GPIOS on the wiki for that very reason.

But it would be great if that information could go back on github, or here. Or wherever :)

Re: programming with a raspberry pi guide

Posted: Mon Sep 14, 2020 8:14 pm
by supaduper
Here is my guide with the info needed to flash with raspberry pi, in one post there is a link to my Raspian 8gb image which has all the programming software on it ready to use
My raspbian is passworded its ` Backlash1`

This was on a Rasp pi 3 but should be ok on a 2...BUT CHECK YOU HAVE THE RIGHT PINOUTS !

viewtopic.php?f=65&t=1348&start=10

Re: programming with a raspberry pi guide

Posted: Mon Sep 14, 2020 8:21 pm
by arkadiusz.makarenko
I have image for RPi Zero. if someone was interested just ping me, I will rip it.

Re: programming with a raspberry pi guide

Posted: Mon Sep 14, 2020 8:41 pm
by oggie
kludge wrote:
Mon Sep 14, 2020 8:10 pm
I think it depends on the model of Pi used. @terriblefire didn’t even specify the GPIOS on the wiki for that very reason.

But it would be great if that information could go back on github, or here. Or wherever :)
That's a good point. My pi is a v1, so those pins are definitely not the same on a 2 or 3

Re: programming with a raspberry pi guide

Posted: Mon Sep 14, 2020 8:46 pm
by terriblefire
The reason i left it off was so that people dont blow up their Pi's and take time to think about the pinouts.