bare minimum components
Moderators: terriblefire, Terriblefire Moderator
- roy-forest-fc.goodall
- Posts: 31
- Joined: Fri Mar 08, 2019 12:06 am
bare minimum components
what are the bare minimum components required to program cpld's on tf534?
-
- Moderator Team
- Posts: 5389
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: bare minimum components
Both CPLDS and the regulator.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
- roy-forest-fc.goodall
- Posts: 31
- Joined: Fri Mar 08, 2019 12:06 am
Re: bare minimum components
so no caps etc then?
-
- Moderator Team
- Posts: 5389
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: bare minimum components
The regulator caps yet.
To ID the jtag chain and program you can probably get away with no caps on a 4 layer board.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
- roy-forest-fc.goodall
- Posts: 31
- Joined: Fri Mar 08, 2019 12:06 am
Re: bare minimum components
Ok thanks for the info
- roy-forest-fc.goodall
- Posts: 31
- Joined: Fri Mar 08, 2019 12:06 am
Re: bare minimum components
one final question
Do i need the flash mem/rom installed to use the tf534 in a 500
Do i need the flash mem/rom installed to use the tf534 in a 500
-
- Moderator Team
- Posts: 5389
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: bare minimum components
Not at all
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
- roy-forest-fc.goodall
- Posts: 31
- Joined: Fri Mar 08, 2019 12:06 am
Re: bare minimum components
so I lied about one final question
what is the best firmware to use?
what is the best firmware to use?
-
- Moderator Team
- Posts: 5389
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: bare minimum components
Use the latest from the TerribleFire binaries github page
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
- roy-forest-fc.goodall
- Posts: 31
- Joined: Fri Mar 08, 2019 12:06 am
Re: bare minimum components
and which end is pin one on the ide connector
and you are a top man for answering these questions
and you are a top man for answering these questions