TF330 rev2 is here

[terriblefire]

The connectors I have have no spring in them at all. The card had a serious tendency to flop around.

@supaduper what do you think?

[supaduper]

The connectors I have have no spring in them at all. The card had a serious tendency to flop around.

@supaduper what do you think?

No real problems here Steve, I suppose if you wanted to manually file more of a bevel on the TF330 you can I suppose, because you moved the inner layers on the PCB so they do not encroach into the card edge like on the Rev1 am I correct bud ?

Just to say that if you can file a bigger bevel easily, as I did on a few of the TF328`s with ease

[terriblefire]

Yeah there are no inner layers beyond the notch.

[supaduper]

Cheers Steve

Then what I say to Alen is get a small needle file and manually increase the bevel on the Rev 2 , like I said I have done a few of the TF328`s when they did not put a bevel on them and I filed a bevel on one in less than a couple of minutes. piece of pi$$

[terriblefire]

I pay the board house to do this but they never do

[8 Bit Dreams]

Hello Stephen,
got parcels You sent to me, have built rev.2 TF330 with XC95288XL,
can You please recompile firmware for it, otherwise i am unable to flash
Thank You

[terriblefire]

already published

https://github.com/terriblefire/terribl ... _alpha.zip

[8 Bit Dreams]

already published

https://github.com/terriblefire/terribl ... _alpha.zip

Nope Steve,
this jed is for 144 , not for 288

[terriblefire]

you nutcase.. i'll do that in in the morning

[alenppc]

Closeup pic of the damage...

dmg1.jpg (166.35 KiB) Viewed 4522 times

And a 1.2mm board sitting nicely

1.2mm.jpg (175.86 KiB) Viewed 4522 times