For the chamefer, the sanding jig (suggested by Stephen) is definitely the way to go. I just did both of mine and it all worked out perfectly. Went for a 45 degree angle and used 120 grit sandpaper. I first tested on a few versa64 carts that I had spares of. When I did the TF330 PCBs, I wrapped them in paper to make sure they didn't get scratched.
There are some pictures of what I did here and a short vid giving you an idea.
I just grabbed some dressed pine I had laying around, bought 2x timber wall brackets from the hardware store, cut one end on each and nailed it all together. All done and dusted in less than an hour! I felt much better doing it this way than trying with a knife which would end up with me in a state of terrible bleeding. I also noticed that my PCBs were slightly warped (maybe the fab process, maybe shipping etc) which might be why the knife method is hit and miss.
Sales Thread (TF330 Bare Boards)
Moderators: terriblefire, Terriblefire Moderator
-
- Moderator Team
- Posts: 5368
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: Sales Thread (TF330 Bare Boards)
Nice work. Wish the board houses would bloody do this
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Re: Sales Thread (TF330 Bare Boards)
That looks impressive, very nicely done
Re: Sales Thread (TF330 Bare Boards)
Hi Steve, if you get any more TF330 boards in I would like 2 please! Would be nice to give my old CD32 a bit of an upgrade! Cheers.
-
- Moderator Team
- Posts: 5368
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: Sales Thread (TF330 Bare Boards)
I have none at the moment. I may do another order soon.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
Re: Sales Thread (TF330 Bare Boards)
Still interested in some more boards here as well if you're ordering
Re: Sales Thread (TF330 Bare Boards)
Hi,
I see in the first post there are none available, does anyone know if it's still possible to buy bare boards?
I see in the first post there are none available, does anyone know if it's still possible to buy bare boards?
-
- Moderator Team
- Posts: 5368
- Joined: Mon Aug 28, 2017 10:56 pm
- Location: Glasgow, UK
Re: Sales Thread (TF330 Bare Boards)
I'm considering doing another run. But please check with AlenPPC and Superduper (maybe 8 Bit Dreams too).. they might sell you a bare board. Id rather not do another run until needed.
———
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
"It is not necessarily a supply voltage at no load, but the amount of current it can provide when touched that
indicates how much hurting you shall receive."
- 8 Bit Dreams
- Moderator Team
- Posts: 785
- Joined: Fri Nov 09, 2018 7:12 am
- Location: Germany
Re: Sales Thread (TF330 Bare Boards)
All 50x sold, no pcbs left, sorry...
Retro computer hardware & repair in Germany
Re: Sales Thread (TF330 Bare Boards)
I have a few left.