Page 4 of 9

Re: Sales Thread (TF330 Bare Boards)

Posted: Wed Apr 24, 2019 8:09 am
by terriblefire
An apology to anyone who ordered since last Thursday. I’ve not managed to get stuff posted due to Easter etc. Will get everything posted tonight

Re: Sales Thread (TF330 Bare Boards)

Posted: Thu Apr 25, 2019 2:20 pm
by terriblefire
All boards posted. Message me if you are after some.

Re: Sales Thread (TF330 Bare Boards)

Posted: Tue Apr 30, 2019 8:12 pm
by terriblefire
13 boards left after posting everyones. :)

EDIT: Sorry all gone. More on order

Re: Sales Thread (TF330 Bare Boards)

Posted: Tue May 07, 2019 2:12 pm
by Error42
Hi Stephen, I'd be interested in one of the TF330 boards when they become available again.
I've also got to get hold of a riser too, but I know that's not your department :-)

Re: Sales Thread (TF330 Bare Boards)

Posted: Thu May 09, 2019 12:38 am
by dalek
My boards (2x TF330 and 2x TF534) arrived safely in Australia. Sexy matte black TF330 here we come :)

Re: Sales Thread (TF330 Bare Boards)

Posted: Thu May 09, 2019 4:09 am
by dalek
I noticed on the 2 TF330 matte black boards that the edge connector is not beveled (unlike the TF328 boards I received from Stephen that were beveled).

Has anyone tried inserting cards with non-beveled edges? I recall it could break pins on the riser. Best way to home bevel would be sandpaper?

Re: Sales Thread (TF330 Bare Boards)

Posted: Thu May 09, 2019 7:28 am
by terriblefire
I’ve tried and tried to get board houses to do this and they don’t. Alenppc and I have had lots of fights with all the board houses...

I’ve never had issues without the bevel but I know some have. Fine sandpaper and a jig is the best way

Re: Sales Thread (TF330 Bare Boards)

Posted: Thu May 09, 2019 6:00 pm
by alenppc
You definitely should file the edge or you'll break the connector sooner or later. I was doing it with a knife for a while but ended up accidentally damaging some boards, now I use the dull (outer) scissor edge and it seems to do the trick without damage.

Re: Sales Thread (TF330 Bare Boards)

Posted: Fri May 10, 2019 12:46 am
by dalek
Thanks for the tips, but I think now I'm scared! I'll definitely sand and/or file them down (before building!)

Re: Sales Thread (TF330 Bare Boards)

Posted: Fri May 10, 2019 3:32 pm
by alenppc
Stephen and I experimented with adding 0.7 mm to the card edge past the connector and this definitely makes filing them a bit easier - of course ideally the board house would do it but for some reason they keep ignoring instructions... I sent quality complaints but all they amount to is "we'll be more careful next time"...