The beginning..

Post by **exxos** » Thu Oct 29, 2020 9:37 pm

Everyone is a witness...

: Capture.PNG (680.27 KiB) Viewed 2705 times

: Capture.PNG (269.7 KiB) Viewed 2701 times

DoG · Post by **DoG** » Thu Oct 29, 2020 9:54 pm

Isn't all the fault due to drill distance? Vias or mounting holes intersecting tracks?

EDIT: Should say overlap instead. Hmm...

EDIT2: But you run EAGLE 7 or something?

DoG · Post by **DoG** » Thu Oct 29, 2020 10:02 pm

Aah. Drill distance is when two hole are to close to each other. Vias and holes. Never mind then.

Post by **exxos** » Thu Oct 29, 2020 10:16 pm

DoG wrote: ↑Thu Oct 29, 2020 10:02 pm Aah. Drill distance is when two hole are to close to each other. Vias and holes. Never mind then.

It was "overlaps" where the problems all were. I was using Eagle 7 and Eagle 9 to check DRC errors.

Post by **exxos** » Thu Oct 29, 2020 11:18 pm

All I did was move the S2 header, now its magically got 43 wire stubs from before... This is what I mean about Eagle, stuff just doesn't work right

: Capture.PNG (138.42 KiB) Viewed 2675 times

EDIT:

Did all those, then ran DRC again, it found another 4

Did those then found another 2.. Ran DRC serveral times.. nothing..

Restarted Eagle and...

: Capture.PNG (142.46 KiB) Viewed 2665 times

Badwolf · Post by **Badwolf** » Fri Oct 30, 2020 1:56 pm

exxos wrote: ↑Thu Oct 29, 2020 11:18 pm This is what I mean about Eagle, stuff just doesn't work right

The metaphorical smack on the arse by the midwife that is Eagle, delivering a bouncing baby KiCAD user?

BW.

The beginning..

Re: The beginning..

Re: The beginning..

Re: The beginning..

Re: The beginning..

Re: The beginning..

Re: The beginning..